Connect echo to digital pin 6 on your arduino board.
Ultrasonic flow sensor arduino.
In this tutorial you will learn how to use one water flow sensor with an arduino board.
There are four pins on the hc sr04.
The water flow sensor consists of a plastic valve body a water rotor and a hall effect sensor.
Considering the travel time and the speed of the sound you can calculate the distance.
Connect trigger to digital pin 7 on your arduino board.
Therefore we can get the distance from the ultrasonic sensor by using two arduino s pins.
The hc sr04 is an ultrasonic ranging module.
It emits an ultrasound at 40 000 hz 40khz which travels through the air and if there is an object or obstacle on its path it will bounce back to the module.
The ultrasonic pulses collide an object and leaves in the other direction the echo terminals receives the ultrasound pulses and the sensor calculates the distance based on the time of the pulses.
You can watch the video of the design here.
Ultrasonic sensor hc sr04 is a sensor that can measure distance.
This economical sensor provides 2cm to 400cm of non contact measurement functionality with a ranging accuracy that can reach up to 3mm.
One pin is connected to trig pin to generate 10µs pulse to trig pin of the sensor.
The ultrasonic sensor has four terminals 5v trigger echo and gnd connected as follows connect the 5v pin to 5v on your arduino board.
When the water flows through the rotor rotor rolls and the speed of it changes with a different rate of flow.
Each hc sr04 module includes an ultrasonic transmitter a receiver and a control circuit.
Circuit for controlling a water flow sensor using arduino mega arduino circuit for measuring the amount of water flowing through a pipe using arduino board.
One of the projects that have been done by so many students is the automated flow switch system that comes under various names like water level indicator using arduino and ultrasonic sensor water level monitor and control automatic flow switch water level sensor water level controller.